Plus Two Physics · Current Electricity

Ohm's law: V–I graph, series and parallel

Vary the current with a rheostat and read the voltmeter and ammeter. For a resistor, V = I R, so the V–I graph is a straight line through the origin with slope R. Then check how resistances combine in series and in parallel.

Cell 4.5 V Key K (closed) Rheostat Rh = 5.0 Ω Ammeter A 0.000 A Voltmeter V 0.00 V

The voltmeter is connected across the resistor network. The ammeter is in series with it. Change the rheostat to change the current.

Connect
—
Current — · voltage —

The idea

For a metallic conductor at constant temperature the current is proportional to the potential difference across it (Ohm's law). The ratio V/I is the resistance R, and it does not depend on the current.

  • Single resistor: V = I R, so R = V / I (slope of the V–I graph)
  • In series: Rs = R₁ + R₂
  • In parallel: 1/Rp = 1/R₁ + 1/R₂, or Rp = R₁R₂ / (R₁ + R₂)

Observations

—

Rh (Ω)I (A)V (V)R = V / I (Ω)
Mean R—

    Summary of all four arrangements

    ArrangementReadingsMeasured R (Ω)Expected (Ω)

    Graph

    Plot V against I for the arrangement selected above. This is a straight line through the origin whose slope is R.

    Take at least 2 readings to see the best-fit line.

    Precautions

    • Connect the ammeter in series and the voltmeter in parallel, with the positive terminals towards the positive of the cell.
    • Check the zero error of both meters before starting.
    • Keep the key closed only while taking a reading, so that the resistor does not heat up and change its resistance.
    • Use the rheostat to keep the current small enough that the resistor does not become hot.
    • Take readings with the needle well deflected, not near the zero of the scale, to reduce the percentage error.
    • A real voltmeter draws a small current, so the measured resistance is very slightly less than the true value.